banner

News

Home

News

  • Reactive Diluent Dosage in Epoxy Adhesive
    October 11, 2026

    Reactive diluent dosage in epoxy adhesive is not a free parameter you can set by feel. Every 10 phr you add shifts the mix viscosity, the epoxy equivalent weight, and the hardener ratio at once. Yolatech supplies two diluents for this work: YLD-6009 and YLD-6021. Both stay reactive inside the film....

    Read More
  • Epoxy Floor Coating Diluent: BGE vs Cardanol Grades
    October 10, 2026

    Epoxy floor coating diluent is a reactive additive that cuts viscosity so the mixed resin self-levels and wets the substrate. Yolatech supplies three types: BGE YLD-9004, cardanol glycidyl ether YLD-9006, and cardanol diglycidyl ether YLD-9014. They crosslink into the film rather than evaporating....

    Read More
  • Low Stress Epoxy Resin for Electronic Encapsulation
    October 09, 2026

    Low stress epoxy resin for electronic encapsulation is a formulation answer to one failure mode: package cracking at solder reflow. The cause is a thermal mismatch, because the resin, copper, and silicon expand at different rates. Yolatech meets this with the DOPO-HQ modified phenolic epoxy series....

    Read More
  • Yolatech at Middle East Coatings Show 2026 in Dubai
    October 08, 2026

    Middle East Coatings Show 2026 is the MENA region's largest coatings exhibition, held 28 to 30 September 2026 in Dubai. It ran at the Dubai Exhibition Centre in Expo City Dubai, where Yolatech showed epoxy resins, curing agents and reactive diluents at the joint booth NA90. The show runs biennially....

    Read More
  • Structural Adhesive Curing Agent: HTDA, MXDA or DACH?
    October 08, 2026

    A structural adhesive curing agent is the component that decides whether a bonded joint holds at 80 °C or creeps apart. Yolatech supplies three amine types for that job: HTDA, MXDA, and DACH. Each one trades cure speed against heat resistance and pot life. All three cure fully at room temperature....

    Read More
  • Yolatech at Latin American Coatings Show 2026
    October 07, 2026

    Latin American Coatings Show 2026 is the 19th edition of Mexico's national coatings, inks and surface-treatment exhibition. It ran from 21 to 23 July 2026 at Centro Banamex in Mexico City, organised by ANAFAPYT. Yolatech exhibited epoxy resins, curing agents and reactive diluents at the Mexico show....

    Read More
  • Epoxy Resin for Wind Turbine Blades: Grade Guide
    October 06, 2026

    Wind turbine blade epoxy resin is an infusion-grade epoxy system built for long fatigue life and full fibre wet-out. Yolatech supplies it as two matched parts: a low-viscosity bisphenol F resin for fast wet-out, and a bisphenol A resin for joint stiffness. Both parts cure with polyetheramine D-230....

    Read More
  • Resorcinol Diglycidyl Ether YLD-6010: Data and Dosage
    October 05, 2026

    Resorcinol diglycidyl ether YLD-6010 (CAS 101-90-6) is a low-viscosity aromatic epoxy diluent that lifts crosslink density in heat-resistant systems. Yolatech supplies it as a transparent liquid, melting point 33–35 °C, EEW 117–129 g/eq, viscosity 40–100 mPa·s at 40 °C. It also thins phenolic resin....

    Read More
  • Yolatech at ASE CHINA 2026: Epoxy Resins in Shanghai
    October 05, 2026

    ASE CHINA 2026 is the 29th China International Adhesives and Sealants Exhibition, held in Shanghai from 15 to 17 September 2026. Nanjing Yolatech Co., Ltd. exhibited at booth E2676 in Hall E2 of the Shanghai New International Expo Centre, presenting epoxy resins, curing agents and reactive diluents....

    Read More
  • Yolatech Attends 2026 Epoxy Resin and Curing Agent Application Technology Training
    July 30, 2026

    Jinan, China – July 30, 2026 – Yolatech, a specialist in the development and export of epoxy resins, curing agents, and reactive diluents, is participating in the 2026 Epoxy Resin and Curing Agent Application Technology Training, held from July 29 to 31 in Jinan, Shandong Province . The...

    Read More
  • Yolatech Showcases Advanced Epoxy Solutions at ACMIE 2026
    April 20, 2026

    April 14–15, 2026 — The “2026 Chemical New Materials and Fine Chemicals Conference & Exhibition (ACMIE 2026)”, alongside the “Asia Silicon Technology Conference (AST 2026)” and the “National Catalysis and Catalyst Expo,” successfully concluded in B...

    Read More
  • Invitation | Meet Yolatech at Asia Pacific Coatings Show 2025!
    July 29, 2025

    Dear Partners and Friends, We are pleased to invite you to visit us at the Asia Pacific Coatings Show 2025, taking place from September 3rd to 5th in Bangkok, Thailand. You’ll find Yolatech at Booth No. 3D27! Yolatech specializes in the development and export of epoxy resins, curing agents, an...

    Read More
1 2 3
A total of3pages

leave a message

leave a message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.
submit

home

products

WhatsApp

Contact Us